4
Installation Instructions
Unpacking
To ensure the best performance from your new
Smart Drive® please follow the instructions below.
Removing the Packaging
1
Remove the outer packaging.
2
Tilt the machine backwards and walk it off the bottom
packer one foot at a time.
3
Remove the bottom packer from under the machine by
pulling it out the front.
4
Lift the lid and remove the bowl packer from the bowl.
5
Remove the hoses and accessories.
6
Keep the bottom packer and bowl packer in case they
are required for future transit.
In your autowasher you will find:
4 rubber inserts for the levelling feet (joined together).
1 hose guide.
2 inlet hoses.
Drain Hose
1
Carefully pull the drain hose out from the
back of the machine by pulling the exposed
part of the hose downward and outward.
2
To guide the drain hose over the tub or
standpipe the hose guide MUST be fitted to
the drain hose.
To prevent syphoning:
The drain hose should not extend more than
20mm from the end of the guide.
The height of the standpipe or tub should
be between 850 – 1200mm.
The drain hose can be trimmed to length.
3
Place the drain hose in the tub or standpipe.
Please ensure that the bottom packer has been removed before operating your machine.
Pull hose
through guide
(20mm)
maximum
Flex hose
guide apart
Standpipe 850 – 1200mm
